Nick: sekret
E-mail: none
Board: unknown
Contents: 
# flashrom -p internal -v dump.rom
flashrom v1.3.0 on Linux 6.2.8-arch1-1 (x86_64)
flashrom is free software, get the source code at https://flashrom.org

Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns).
No DMI table found.
Found chipset "Intel Tiger Lake U Premium".
Enabling flash write... SPI Configuration is locked down.
The Flash Descriptor Override Strap-Pin is set. Restrictions implied by
the Master Section of the flash descriptor are NOT in effect. Please note
that Protected Range (PR) restrictions still apply.
FREG0: Flash Descriptor region (0x00000000-0x00000fff) is read-write.
FREG1: BIOS region (0x00500000-0x00ffffff) is read-write.
FREG2: Management Engine region (0x00001000-0x004fffff) is read-write.
Enabling hardware sequencing because some important opcode is locked.
OK.
Found Programmer flash chip "Opaque flash chip" (16384 kB, Programmer-specific) on internal.
Verifying flash... FAILED at 0x00000000! Expected=0x11, Found=0xff, failed byte count from 0x00000000-0x00ffffff: 0x29a833