Nick: pc
E-mail: none
Board: nic3com/3C90xB
Contents: 
flashrom v2.0.0-devel (git:v1.8.0-10-g7f1ca6fd) on Linux 6.12.39-lenochod+ (x86_64)
flashrom is free software, get the source code at https://flashrom.org

flashrom was built with GCC 15.3.0, little endian
Command line (7 args): flashrom -V -p nic3com -c Am29F010 -r /tmp/dumpA.bin
Initializing nic3com programmer
Found "3COM 3C90xB: PCI 10/100 Mbps; shared 10BASE-T/100BASE-TX" (10b7:9055, BDF 05:00.0).
Requested BAR is of type I/O
I/O BAR access requested, but flashrom does not support I/O BAR access on this platform (yet).
Requested BAR is of type I/O
I/O BAR access requested, but flashrom does not support I/O BAR access on this platform (yet).
The following protocols are supported: Parallel.
Probing for AMD Am29F010, 128 kB: probe_jedec: id1 0x01, id2 0x20
Added layout entry 00000000 - 0001ffff named complete flash
Found AMD flash chip "Am29F010" (128 kB, Parallel) on nic3com.
===
This flash part has status UNTESTED for operations: PROBE READ ERASE WRITE WP
The test status of this chip may have been updated in the latest development
version of flashrom. If you are running the latest development version,
please email a report to flashrom@flashrom.org if any of the above operations
work correctly for you with this flash chip. Please include the flashrom log
file for all operations you tested (see the man page for details), and mention
which mainboard or programmer you tested in the subject line.
You can also try to follow the instructions here:
https://www.flashrom.org/contrib_howtos/how_to_mark_chip_tested.html
Thanks for your help!
Reading flash... read_flash:  region (00000000..0x01ffff) is readable, reading range (00000000..0x01ffff).
done.
Runtime from programmer init to shutdown: 0min 1sec