Nick: janmann
E-mail: none
Board: topton x2e n150
Contents: 
$ sudo flashrom -p internal -w seauboot_x2e_n150_fspgop.rom 
flashrom v1.6.0 on FreeBSD 14.3-RELEASE-p7 (amd64)
flashrom is free software, get the source code at https://flashrom.org

No DMI table found.
Found chipset "Intel Alder Lake-N".
Enabling flash write... Warning: Setting BIOS Control at 0xdc from 0x88 to 0x89 failed.
New value is 0x88.
SPI Configuration is locked down.
FREG0: Flash Descriptor region (0x00000000-0x00000fff) is read-write.
FREG1: BIOS region (0x00600000-0x00ffffff) is read-write.
FREG2: Management Engine region (0x00001000-0x00413fff) is read-write.
Enabling hardware sequencing because some important opcode is locked.
PROBLEMS, continuing anyway
========================================================================
You may be running flashrom on an unknown laptop. We could not
detect this for sure because your vendor has not set up the SMBIOS
tables correctly. Some internal buses have been disabled for
safety reasons. You can enforce using all buses by adding
  -p internal:laptop=this_is_not_a_laptop
to the command line, but please read the following warning if you
are not sure.

Laptops, notebooks and netbooks are difficult to support and we
recommend to use the vendor flashing utility. The embedded controller
(EC) in these machines often interacts badly with flashing.
See the manpage and https://flashrom.org/contrib_howtos/laptops_and_ec.html
for details.

If flash is shared with the EC, erase is guaranteed to brick your laptop
and write may brick your laptop.
Read and probe may irritate your EC and cause fan failure, backlight
failure and sudden poweroff.
You have been warned.
========================================================================
Found Winbond flash chip "W25Q128.V" (16384 kB, Programmer-specific) on internal.
Reading old flash chip contents... done.
Updating flash chip contents... Transaction error between offset 0x00601000 and 0x00601000 (= 0x00601000 + 0)!
Erase/write done from 0 to ffffff
Write Failed!Uh oh. Erase/write failed. Checking if anything has changed.
Reading current flash chip contents... done.
Apparently at least some data has changed.
Your flash chip is in an unknown state.
Get help on chat (see https://flashrom.org/contact.html) or mail
flashrom@flashrom.org with the subject "FAILED: <your board name>"!-------------------------------------------------------------------------------
DO NOT REBOOT OR POWEROFF!