Nick: medi
E-mail: none
Board: unknown
Contents: 
$ sudo flashrom --programmer internal --read bios.backup
flashrom v1.2 on Linux 4.18.0-348.7.1.el8_5.x86_64 (x86_64)
flashrom is free software, get the source code at https://flashrom.org

Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns).
No DMI table found.
Found chipset "Intel H67".
Enabling flash write... Warning: Setting Bios Control at 0xdc from 0x02 to 0x01 failed.
New value is 0x02.
SPI Configuration is locked down.
FREG0: Flash Descriptor region (0x00000000-0x00000fff) is read-only.
FREG2: Management Engine region (0x00003000-0x001fffff) is locked.
Not all flash regions are freely accessible by flashrom. This is most likely
due to an active ME. Please see https://flashrom.org/ME for details.
At least some flash regions are read protected. You have to use a flash
layout and include only accessible regions. For write operations, you'll
additionally need the --noverify-all switch. See manpage for more details.
OK.
Found Winbond flash chip "W25Q32.V" (4096 kB, SPI) mapped at physical address 0x00000000ffc00000.
Reading flash... Transaction error!
Read operation failed!
FAILED.
$ man flashrom
$ sudo flashrom --programmer internal --read bios.backup --ifd
flashrom v1.2 on Linux 4.18.0-348.7.1.el8_5.x86_64 (x86_64)
flashrom is free software, get the source code at https://flashrom.org

Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns).
No DMI table found.
Found chipset "Intel H67".
Enabling flash write... Warning: Setting Bios Control at 0xdc from 0x02 to 0x01 failed.
New value is 0x02.
SPI Configuration is locked down.
FREG0: Flash Descriptor region (0x00000000-0x00000fff) is read-only.
FREG2: Management Engine region (0x00003000-0x001fffff) is locked.
Not all flash regions are freely accessible by flashrom. This is most likely
due to an active ME. Please see https://flashrom.org/ME for details.
At least some flash regions are read protected. You have to use a flash
layout and include only accessible regions. For write operations, you'll
additionally need the --noverify-all switch. See manpage for more details.
OK.
Found Winbond flash chip "W25Q32.V" (4096 kB, SPI) mapped at physical address 0x00000000ffc00000.
Reading ich descriptor... done.
Reading flash... done.