Nick: hell
E-mail: NULL
Board: Acer E5-573 / Extensa 2511 (Quanta ZRT)
Contents: 
flashrom v1.2-910-gf6d9a28 on Linux 5.18.0-arch1-1 (x86_64)
flashrom is free software, get the source code at https://flashrom.org

Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns).
No DMI table found.
Found chipset "Intel Lynx Point LP Mainstream".
This chipset is marked as untested. If you are using an up-to-date version
of flashrom *and* were (not) able to successfully update your firmware with it,
then please email a report to flashrom@flashrom.org including a verbose (-V) log.
Thank you!
Enabling flash write... SPI Configuration is locked down.
FREG0: Flash Descriptor region (0x00000000-0x00000fff) is read-only.
FREG1: BIOS region (0x00200000-0x007fffff) is read-write.
FREG2: Management Engine region (0x00001000-0x001fffff) is locked.
Not all flash regions are freely accessible by flashrom. This is most likely
due to an active ME. Please see https://flashrom.org/ME for details.
PR0: Warning: 0x006c0000-0x007fffff is read-only.
PR1: Warning: 0x00315000-0x005bffff is read-only.
At least some flash regions are read protected. You have to use a flash
layout and include only accessible regions. For write operations, you'll
additionally need the --noverify-all switch. See manpage for more details.
OK.
Found Winbond flash chip "W25Q64BV/W25Q64CV/W25Q64FV" (8192 kB, SPI) mapped at physical address 0x00000000ff800000.
Found Winbond flash chip "W25Q64JV-.Q" (8192 kB, SPI) mapped at physical address 0x00000000ff800000.
Multiple flash chip definitions match the detected chip(s): "W25Q64BV/W25Q64CV/W25Q64FV", "W25Q64JV-.Q"
Please specify which chip definition to use with the -c <chipname> option.