Nick: Norky
E-mail: none
Board: nicintel_spi
Contents: 
dan@skein ~/firmware> flashrom --list-supported | grep -A6 nicintel_spi
pony_spi, nicintel, nicintel_spi, nicintel_eeprom, ogp_spi, satamv, linux_mtd,
linux_spi, usbblaster_spi, pickit2_spi, ch341a_spi, digilent_spi, jlink_spi,
stlinkv3_spi

Supported devices for the internal programmer:

Supported chipsets (total: 351):
--
Supported PCI devices for the nicintel_spi programmer:
Vendor  Device                                                     PCI IDs    Status
Intel   82571EB Gigabit Ethernet Controller                        8086:105e  OK
Intel   82541GI Gigabit Ethernet Controller                        8086:1076  OK
Intel   82541PI Gigabit Ethernet Controller                        8086:107c  OK
Intel   82572EI Gigabit Ethernet Controller                        8086:10b9  OK
Intel   82574L Gigabit Ethernet Controller                         8086:10d3  OK
dan@skein ~/firmware> lspci -d 8086::0200 -v
00:1f.6 Ethernet controller: Intel Corporation Ethernet Connection (2) I219-LM (rev 31)
        DeviceName: Onboard Lan
        Subsystem: Hewlett-Packard Company Device 802f
        Flags: bus master, fast devsel, latency 0, IRQ 137
        Memory at d1200000 (32-bit, non-prefetchable) [size=128K]
        Capabilities: <access denied>
        Kernel driver in use: e1000e
        Kernel modules: e1000e

02:00.0 Ethernet controller: Intel Corporation 82574L Gigabit Network Connection
        Subsystem: Intel Corporation Gigabit CT Desktop Adapter
        Flags: bus master, fast devsel, latency 0, IRQ 17
        Memory at d1080000 (32-bit, non-prefetchable) [size=128K]
        Memory at d1000000 (32-bit, non-prefetchable) [size=512K]
        I/O ports at 3000 [disabled] [size=32]
        Memory at d10a0000 (32-bit, non-prefetchable) [size=16K]
        Expansion ROM at d10c0000 [disabled] [size=256K]
        Capabilities: <access denied>
        Kernel driver in use: e1000e
        Kernel modules: e1000e

dan@skein ~/firmware> lspci -n -s 2:
02:00.0 0200: 8086:10d3
dan@skein ~/firmware> sudo flashrom --programmer nicintel_spi:pci=2:0.0 --read test.bin -V
flashrom v1.2 on Linux 5.15.7-200.fc35.x86_64 (x86_64)
flashrom is free software, get the source code at https://flashrom.org

flashrom was built with libpci 3.7.0, GCC 11.1.1 20210623 (Red Hat 11.1.1-6), little endian
Command line (5 args): flashrom --programmer nicintel_spi:pci=2:0.0 --read test.bin -V
Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns).
Initializing nicintel_spi programmer
Error: No supported PCI device found.
Error: Programmer initialization failed.