Nick: arisjr
E-mail: none
Board: unknown
Contents: 
$ sudo flashrom -p internal -r backup.rom -c W25Q64.W 
flashrom v1.2 on Linux 5.4.0-kali2-amd64 (x86_64)
flashrom is free software, get the source code at https://flashrom.org

Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns).
Found chipset "Intel Lynx Point LP Premium".
This chipset is marked as untested. If you are using an up-to-date version
of flashrom *and* were (not) able to successfully update your firmware with it,
then please email a report to flashrom@flashrom.org including a verbose (-V) log.
Thank you!
Enabling flash write... Warning: BIOS region SMM protection is enabled!
Warning: Setting Bios Control at 0xdc from 0x22 to 0x01 failed.
New value is 0x22.
SPI Configuration is locked down.
FREG0: Flash Descriptor region (0x00000000-0x00000fff) is read-only.
FREG2: Management Engine region (0x00001000-0x002fffff) is locked.
Not all flash regions are freely accessible by flashrom. This is most likely
due to an active ME. Please see https://flashrom.org/ME for details.
PR0: Warning: 0x00700000-0x007fffff is read-only.
PR1: Warning: 0x00324000-0x006a1fff is read-only.
At least some flash regions are read protected. You have to use a flash
layout and include only accessible regions. For write operations, you'll
additionally need the --noverify-all switch. See manpage for more details.
OK.
No EEPROM/flash device found.
Note: flashrom can never write if the flash chip isn't found automatically.