Nick: Rhylx E-mail: none Board: unknown Contents: flashrom v1.0.1 on Linux 5.0.11-arch1-1-ARCH (x86_64) flashrom was built with libpci 3.6.2, GCC 8.2.1 20181127, little endian Command line (4 args): flashrom -p internal -o logfile.txt Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns). Initializing internal programmer No coreboot table found. Using Internal DMI decoder. DMI string chassis-type: "Portable" Laptop detected via DMI. DMI string system-manufacturer: "Dell Inc. " DMI string system-product-name: "Dell System Vostro 3360" DMI string system-version: "Not Specified" DMI string baseboard-manufacturer: "Dell Inc. " DMI string baseboard-product-name: "0RGR2N" DMI string baseboard-version: "A00" W836xx enter config mode worked or we were already in config mode. W836xx leave config mode had no effect. Active config mode, unknown reg 0x20 ID: 85. Found ITE EC, ID 0x8518, Rev 0x08 on port 0x4e. ======================================================================== WARNING! You seem to be running flashrom on an unsupported laptop. Laptops, notebooks and netbooks are difficult to support and we recommend to use the vendor flashing utility. The embedded controller (EC) in these machines often interacts badly with flashing. See the manpage and https://flashrom.org/Laptops for details. If flash is shared with the EC, erase is guaranteed to brick your laptop and write may brick your laptop. Read and probe may irritate your EC and cause fan failure, backlight failure and sudden poweroff. You have been warned. ======================================================================== Aborting. Error: Programmer initialization failed.