Nick: capin
E-mail: me@chrisrjones.com
Board: mbp-2012-mid
Contents: 
flashrom v1.0 on Darwin 17.7.0 (x86_64)
flashrom was built with LLVM Clang 9.1.0 (clang-902.0.39.1), little endian
Command line (9 args): flashrom -V -p buspirate_spi:dev=/dev/tty.usbserial-A700dzDq -c N25Q064..1E -r eeprom-dump-01.bin -o flashrom-25q.log
Calibrating delay loop... OS timer resolution is 1 usecs, 2649M loops per second, 10 myus = 11 us, 100 myus = 158 us, 1000 myus = 1114 us, 10000 myus = 9742 us, 4 myus = 5 us, OK.
Initializing buspirate_spi programmer
Detected Bus Pirate hardware v3.a
Detected Bus Pirate firmware 7.1 ("v7.1")
Using SPI command set v2.
SPI speed is 8MHz
Raw bitbang mode version 1
Raw SPI mode version 1
The following protocols are supported: SPI.
Probing for Micron/Numonyx/ST N25Q064..1E, 8192 kB: RDID byte 0 parity violation. probe_spi_rdid_generic: id1 0xff, id2 0xffff
No EEPROM/flash device found.
Note: flashrom can never write if the flash chip isn't found automatically.
Raw bitbang mode version 1
Bus Pirate shutdown completed.