Nick: escalade E-mail: none Board: Wintel Pro CX-W8 (Z8300) update Contents: Updating the board from https://paste.flashrom.org/view.php?id=3002 to https://paste.flashrom.org/view.php?id=3003 Calibrating delay loop... OK. No DMI table found. Found chipset "Intel Braswell". This chipset is marked as untested. If you are using an up-to-date version of flashrom *and* were (not) able to successfully update your firmware with it, then please email a report to flashrom@flashrom.org including a verbose (-V) log. Thank you! Enabling flash write... Warning: BIOS region SMM protection is enabled! Warning: Setting Bios Control at 0x0 from 0x22 to 0x01 failed. New value is 0x22. Warning: SPI Configuration Lockdown activated. OK. Found Winbond flash chip "W25Q64.W" (8192 kB, SPI) mapped at physical address 0x00000000ff800000. Reading old flash chip contents... done. Erasing and writing flash chip... Transaction error! spi_block_erase_20 failed during command execution at address 0x416000 Reading current flash chip contents... done. Looking for another erase function. spi_block_erase_52 failed during command execution at address 0x410000 Reading current flash chip contents... done. Looking for another erase function. spi_block_erase_d8 failed during command execution at address 0x410000 Reading current flash chip contents... done. Looking for another erase function. spi_chip_erase_60 failed during command execution Reading current flash chip contents... done. Looking for another erase function. spi_chip_erase_c7 failed during command execution Looking for another erase function. No usable erase functions left. FAILED! Uh oh. Erase/write failed. Checking if anything has changed. Reading current flash chip contents... done. Apparently at least some data has changed. Your flash chip is in an unknown state. Get help on IRC at chat.freenode.net (channel #flashrom) or mail flashrom@flashrom.org with the subject "FAILED: "! ------------------------------------------------------------------------------- DO NOT REBOOT OR POWEROFF!