Nick: N2
E-mail: none
Board: unknown
Contents: 
pi@raspberrypi:~/frser-duino $ make flash-mega2560
BLBAUD=115200 AVRDUDE_PROGRAMMER="wiring -D" SERIAL_DEV=/dev/ttyACM0 AVRDUDE_MCU=m2560 make program
make[1]: Entering directory '/home/pi/frser-duino'
avr-objcopy -j .text -j .data -O ihex frser-duino.out frser-duino.hex
avrdude -c wiring -D -p m2560 -P /dev/ttyACM0 -b 115200 -U flash:w:frser-duino.hex

avrdude: AVR device initialized and ready to accept instructions

Reading | ################################################## | 100% 0.03s

avrdude: Device signature = 0x1e9801
avrdude: reading input file "frser-duino.hex"
avrdude: input file frser-duino.hex auto detected as Intel Hex
avrdude: writing flash (1574 bytes):

Writing | ################################################## | 100% 0.32s

avrdude: 1574 bytes of flash written
avrdude: verifying flash memory against frser-duino.hex:
avrdude: load data flash data from input file frser-duino.hex:
avrdude: input file frser-duino.hex auto detected as Intel Hex
avrdude: input file frser-duino.hex contains 1574 bytes
avrdude: reading on-chip flash data:

Reading | ################################################## | 100% 0.25s

avrdude: verifying ...
avrdude: 1574 bytes of flash verified

avrdude: safemode: Fuses OK (E:FF, H:D8, L:FF)

avrdude done.  Thank you.

make[1]: Leaving directory '/home/pi/frser-duino'
pi@raspberrypi:~/frser-duino $