Nick: Whinis
E-mail: flashrom@whinis.com
Board: RadioProject
Contents: 
sudo ~/bin/flashrom -c "SST25VF016B" -p ft2232_spi:type=232h -w '/home/****/Desktop/Si468x/FinalImage'  -VV
flashrom v0.9.9-r1954 on Linux 3.19.0-32-generic (x86_64)
flashrom is free software, get the source code at https://flashrom.org

flashrom was built with libpci 3.2.1, GCC 4.8.4, little endian
Command line (7 args): /home/****/bin/flashrom -c SST25VF016B -p ft2232_spi:type=232h -w /home/****/Desktop/Si468x/FinalImage -VV
Calibrating delay loop... OS timer resolution is 1 usecs, 1297M loops per second, delay more than 10% too short (got 69% of expected delay), recalculating... 1301M loops per second, 10 myus = 24 us, 100 myus = 165 us, 1000 myus = 1654 us, 10000 myus = 14554 us, 4 myus = 6 us, OK.
Initializing ft2232_spi programmer
Using device type FTDI FT232H channel A.
Disable divide-by-5 front stage
Set clock divisor
MPSSE clock: 60.000000 MHz, divisor: 2, SPI clock: 30.000000 MHz
No loopback of TDI/DO TDO/DI
Set data bits
The following protocols are supported: SPI.
Probing for SST SST25VF016B, 2048 kB: probe_spi_rdid_generic: id1 0xdf, id2 0x1220
Found SST flash chip "SST25VF016B" (2048 kB, SPI) on ft2232_spi.
Chip status register is 0x00.
Chip status register: Block Protect Write Disable (BPL) is not set
Chip status register: Auto Address Increment Programming (AAI) is not set
Chip status register: Block Protect 3 (BP3) is not set
Chip status register: Block Protect 2 (BP2) is not set
Chip status register: Block Protect 1 (BP1) is not set
Chip status register: Block Protect 0 (BP0) is not set
Chip status register: Write Enable Latch (WEL) is not set
Chip status register: Write In Progress (WIP/BUSY) is not set
Resulting block protection : none
Block protection is disabled.
Reading old flash chip contents... done.
Erasing and writing flash chip... Trying erase function 0... 0x000000-0x000fff:S, 0x001000-0x001fff:S, 0x002000-0x002fff:W