Nick: Burgundy
E-mail: wrunning@ymail.com
Board: ASUS M2N-E
Contents: 
C:\temp\flashrom-0.9.6.1-r1646-mingw>flashrom -V -p dummy -c SST49LF040B -r out.
bin
flashrom v0.9.6.1-r1644 on Windows 6.1 (x86)
flashrom is free software, get the source code at http://www.flashrom.org

flashrom was built with GCC 4.7.2, little endian
Command line (7 args): flashrom -V -p dummy -c SST49LF040B -r out.bin
Calibrating delay loop... OS timer resolution is 1000 usecs, 1001M loops per sec
ond, 10 myus = 0 us, 100 myus = 0 us, 1000 myus = 1000 us, 10000 myus = 10000 us
, 4000 myus = 4000 us, OK.
Initializing dummy programmer
Requested buses are: default
Enabling support for parallel flash.
Enabling support for LPC flash.
Enabling support for FWH flash.
Enabling support for SPI flash.
Not emulating any flash chip.
The following protocols are supported: Parallel, LPC, FWH, SPI.
Probing for SST SST49LF040B, 512 kB: probe_jedec_common: id1 0xff, id2 0xff, id1
 parity violation, id1 is normal flash content, id2 is normal flash content
No EEPROM/flash device found.
Note: flashrom can never write if the flash chip isn't found automatically.