Nick: GNUtoo
E-mail: GNUtoo@no-log.org
Board: openmoko programmer flashing the Lenovo X60 with a pomona cl
Contents: 
flashrom v0.9.6.1-r1668 on Linux 3.8.6-1-LIBRE (x86_64)
flashrom was built with libpci 3.1.10, GCC 4.8.0, little endian
Command line (8 args): ../../flashrom/flashrom -pft2232_spi:type=openmoko -c MX25L1605 -r CHIP.bin -VV -o read.log
Calibrating delay loop... OS timer resolution is 1 usecs, 1318M loops per second, 10 myus = 9 us, 100 myus = 111 us, 1000 myus = 966 us, 10000 myus = 10367 us, 4 myus = 4 us, OK.
Initializing ft2232_spi programmer
Using device type FIC OpenMoko Neo1973 Debug board (V2+) channel A.
FTDI chip type 2 is not high-speed.
Set clock divisor
MPSSE clock: 12.000000 MHz, divisor: 2, SPI clock: 6.000000 MHz
No loopback of TDI/DO TDO/DI
Set data bits
The following protocols are supported: SPI.
Probing for Macronix MX25L1605, 2048 kB: probe_spi_rdid_generic: id1 0xc2, id2 0x2015
Found Macronix flash chip "MX25L1605" (2048 kB, SPI) on ft2232_spi.
Chip status register is 0x00.
Chip status register: Status Register Write Disable (SRWD) is not set
Chip status register: Bit 6 is not set
Chip status register: Bit 5 is not set
Chip status register: Block Protect 2 (BP2) is not set
Chip status register: Block Protect 1 (BP1) is not set
Chip status register: Block Protect 0 (BP0) is not set
Chip status register: Write Enable Latch (WEL) is not set
Chip status register: Write In Progress (WIP/BUSY) is not set
Block protection is disabled.
Reading flash... done.