Nick: mozzwald
E-mail: mozzwald@gmail.com
Board: smc 1211tx
Contents: 
~$ sudo flashrom -p nicrealtek:pci=03:02.0 -r cmos--backup.img -c Pm49FL004 -f -VVV
flashrom v0.9.5.2-r1533 on Linux 3.0.0-16-generic (x86_64), built with libpci 3.1.7, GCC 4.6.1, little endian
flashrom is free software, get the source code at http://www.flashrom.org

Calibrating delay loop... OS timer resolution is 1 usecs, 2190M loops per second, 10 myus = 10 us, 100 myus = 100 us, 1000 myus = 998 us, 10000 myus = 10034 us, 4 myus = 4 us, OK.
Initializing nicrealtek programmer
Found "SMC2 1211TX" (1113:1211, BDF 03:02.0).
PCI header type 0x00
Requested BAR is I/O
The following protocols are supported: Parallel.
No EEPROM/flash device found.
Force read (-f -r -c) requested, pretending the chip is there:
Probing for flash chip 'Pm49FL004' failed.

~$ sudo lscpi -v
--cut--
03:02.0 Ethernet controller: Accton Technology Corporation SMC2-1211TX (rev 10)
	Subsystem: Accton Technology Corporation EN-1207D Fast Ethernet Adapter
	Flags: bus master, medium devsel, latency 64, IRQ 18
	I/O ports at dc00 [size=256]
	Memory at dcdfff00 (32-bit, non-prefetchable) [size=256]
	Expansion ROM at dce00000 [disabled] [size=64K]
	Capabilities: [50] Power Management version 2
	Kernel driver in use: 8139too
	Kernel modules: 8139too