Nick: anonymous
E-mail: none
Board: DG965OT
Contents: 
flashrom v0.9.5-r1503 on Linux 3.0-ARCH (x86_64), built with libpci 3.1.9, GCC 4.6.2 20120120 (prerelease), little endian
flashrom is free software, get the source code at http://www.flashrom.org

Calibrating delay loop... OK.
sh: dmidecode: command not found
dmidecode execution unsuccessful - continuing without DMI info
Found chipset "Intel ICH8DH". Enabling flash write... WARNING: Setting 0xdc from 0x2 to 0x3 on ICH8DH failed. New value is 0x2.
WARNING: SPI Configuration Lockdown activated.
FREG0: WARNING: Flash Descriptor region (0x00000000-0x00000fff) is read-only.
FREG2: WARNING: Management Engine region (0x00003000-0x00034fff) is locked.
FREG4: WARNING: Platform Data region (0x00000000-0x00000fff) is locked.
Please send a verbose log to flashrom@flashrom.org if this board is not listed on
http://flashrom.org/Supported_hardware#Supported_mainboards yet.
Writes have been disabled. You can enforce write support with the
ich_spi_force programmer option, but it will most likely harm your hardware!
If you force flashrom you will get no support if something breaks.
Enabling hardware sequencing because some important opcode is locked.
PROBLEMS, continuing anyway
Found Programmer flash chip "Opaque flash chip" (1024 kB, Programmer-specific) at physical address 0x0.
Reading flash... Transaction error between offset 0x00003000 and 0x0000303f (= 0x00003000 + 63)!
Read operation failed!
FAILED.